LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 40 (Hydraulic Brake System) >> Repair Instructions >> Brake Pressure Modulator Valve Front Brake Pipe Replacement (Left) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2015 Chevrolet Trax and 2015 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:

Refer to Brake Dust Warning .

WARNING:

Refer to Brake Fluid Irritant Warning .

CAUTION:

Refer to Brake Fluid Effects on Paint and Electrical Components Caution .

  1. Remove the battery. Refer to Battery Replacement .
    2. Fig 1: Brake Pressure Modulator Valve (BPMV) Front Brake Pipe Fitting
    GM2599523Courtesy of GENERAL MOTORS COMPANY
  2. Disconnect the brake pressure modulator valve (BPMV) front brake pipe fitting (1) from the BPMV.
  3. Plug the BPMV outlet port to prevent brake fluid loss and contamination.
    4. Fig 2: Front Brake Pipe Retaining Clip
    GM2599528Courtesy of GENERAL MOTORS COMPANY
  4. Release the BPMV front brake pipe from the retaining clip (1).
  5. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  6. Remove the left front tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
    7. Fig 3: Brake Pipe Fitting
    GM2512985Courtesy of GENERAL MOTORS COMPANY
  7. Disconnect the BPMV front brake pipe fitting (1) from the left front brake hose.
  8. Remove the BPMV front brake pipe from the vehicle.
scientia non olet · About LEMON Manuals