LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 35 (Automatic Transmission - 6T40 (MH8 MHB) - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Transmission Rear Mount Replacement (AWD) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2015 Chevrolet Trax and 2015 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Transmission Rear Mount
    GM2759949Courtesy of GENERAL MOTORS COMPANY
  1. Install the transmission rear mount (1) to the vehicle.
    2. Fig 2: Transmission Bracket And Through Bolt
    GM2759935Courtesy of GENERAL MOTORS COMPANY
  2. Install the transmission bracket (2) to the transmission.
    3. Fig 3: Transmission Bracket Fasteners
    GM2842321Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution .

  3. Install the NEW transmission bracket to transmission fasteners (1) and tighten to 100 N.m (74 lb ft) plus 30-40 degrees.
  4. Install the NEW transmission bracket to transmission fastener (2) and tighten to 60 N.m (44 lb ft) plus 60-75 degrees.
    5. Fig 4: Transmission Rear Mount
    GM2759949Courtesy of GENERAL MOTORS COMPANY
  5. Install the NEW transmission rear mount fastener (2) and tighten to 100 N.m (75 lb ft) plus 90 - 105 degrees..
    6. Fig 5: Transmission Bracket And Through Bolt
    GM2759935Courtesy of GENERAL MOTORS COMPANY
  6. Install the New rear transmission mount through bolt (1) and tighten to 80 N.m (59 lb ft) plus 45-60 degrees.
  7. Install the transfer case. Refer to Transfer Case Replacement .
scientia non olet · About LEMON Manuals