Removal Procedure
WARNING: This page is about a different car, the 2015 Chevrolet Trax and 2015 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the battery tray. Refer to Battery Tray Replacement .
- Disconnect the electrical connector (1) from the Electronic Vacuum Pump (EVP) (3).
- Remove the two EVP fasteners (2).
- Position the EVP out of the way.
- Install the engine support fixture. Refer to ENGINE SUPPORT FIXTURE .
- Remove the shift cable bracket to transmission mount bolt (4).
- Loosen the shift cable bracket bolt (5).
- Remove and DISCARD the left transmission mount to bracket bolts (1).
- Remove the left transmission mount to body bolts (2).
- Remove the left transmission mount to body nut (3).
- Remove the transmission mount (6) from the vehicle.
NOTE:
Do Not remove the shift cable bracket bolt.