LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 35 (Automatic Transmission - 6T40 (MH8 MHB) - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Transmission Mount Bracket Replacement - Rear (AWD) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2015 Chevrolet Trax and 2015 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Transmission Bracket And Through Bolt
    GM2759935Courtesy of GENERAL MOTORS COMPANY
  1. Install the transmission bracket (2) to the transmission.
  2. Install the NEW rear transmission through bolt (1). Do not tighten at this time.
    3. Fig 2: Transmission Bracket Fasteners
    GM2842321Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution .

  3. Install the NEW transmission bracket to transmission fasteners (1) and tighten to 100 N.m (74 lb ft) plus 30-40 degrees.
  4. Install the NEW transmission bracket to transmission fastener (2) and tighten to 60 N.m (44 lb ft) plus 60-75 degrees.
    5. Fig 3: Transmission Bracket And Through Bolt
    GM2759935Courtesy of GENERAL MOTORS COMPANY
  5. Install the NEW rear transmission mount through bolt (1) and tighten to 80 N.m (59 lb ft) plus 45-60 degrees.
  6. Install the transfer case. Refer to Transfer Case Replacement .
scientia non olet · About LEMON Manuals