Removal Procedure
WARNING: This page is about a different car, the 2015 Chevrolet Trax and 2015 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
- Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
- Remove the front compartment front center insulator, if equipped. Refer to Front Compartment Front Center Insulator Replacement .
- Remove the fluid drain plug (1).
- Drain transmission fluid into a suitable container.
- Install the fluid drain plug (1) and tighten to 12 N.m (106 lb in).
CAUTION:
Refer to Component Fastener Tightening Caution .