LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 35 (Automatic Transmission - 6T40 (MH8 MHB) - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Front Wheel Drive Shaft Seal Replacement - Right Side (AWD) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2015 Chevrolet Trax and 2015 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Transfer Case-To-Transfer Case Bracket Seal
    GM2759854Courtesy of GENERAL MOTORS COMPANY
  1. Clean the contact surfaces of the transmission, transfer case adapter bracket, and PTU.
  2. Lightly lubricate the adapter seal with transmission oil prior to installation.
    3. NOTE:

    Install the OD groove of the seal onto the raised area in the adapter seal bore. A properly installed seal will be installed 2.66 mm (0.10 in) below the machined surface when measured from the PTU side of bracket.

  3. Install a new transfer case adapter seal (1). Refer to Transfer Case Assemble .
  4. Install the transfer case. Refer to Transfer Case Replacement .
scientia non olet · About LEMON Manuals