LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 29 (HVAC System - Manual) >> Diagnostic Information and Procedures >> Air Conditioning Compressor Malfunction (C67) >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2015 Chevrolet Trax and 2015 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

Refer to HVAC System Malfunction (C67) before performing this procedure

  1. Ignition ON, press and release the A/C Switch.
  2. Verify the scan tool HVAC A/C Switch parameter changes between Active and Inactive.
    • If the parameter does not change 

      Replace the A26 HVAC Controls.

    • If the parameter changes 
  3. Set A/C system to coolest setting with blower ON.
  4. Press and release the A/C switch several times.
  5. Verify the scan tool ECM A/C Request Signal parameter changes between Active and Inactive.
    • If the parameter does not change 

      Replace the K33 HVAC Control Module.

    • If the parameter changes 
  6. Verify the A/C compressor clutch engages when commanding the ECM A/C Relay output function On and Off with a scan tool.
    • If the A/C compressor clutch engages 
  7. All OK.
scientia non olet · About LEMON Manuals