LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 27 (Wiring Systems And Power Management - Repair Instructions) >> Repair Instructions >> Relay Replacement (Within an Electrical Center) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2015 Chevrolet Trax and 2015 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the electrical center cover.
    2. NOTE:
    • Always note the orientation of the relay.
    • If equipped with a notch style relay; observe the location of the notch on the old relay to verify the new relay is installed with the notch in the same location.
    • Ensure that the electrical center is secure, as not to put added stress on the wires or terminals.
  2. Locate the relay. Refer to Electrical Center Identification Views (Encore)Electrical Center Identification Views (Trax) to locate the electrical center where the relay exists.
    3. Fig 1: Removing/Installing Relay
    GM786629Courtesy of GENERAL MOTORS COMPANY
  3. Using the EL-43244 (1) position the tool on opposing corners of the relay (2).
    4. CAUTION:

    Use EL-43244  to pull the relay straight out from the electrical center terminals. The use of pliers or a flat bladed tool could damage the electrical center.

  4. Remove the relay (2) from the electrical center.
scientia non olet · About LEMON Manuals