Circuit/System Verification

WARNING: This page is about a different car, the 2015 Chevrolet Trax and 2015 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.

Verify no DTC is set.
- If any DTC is set
  Refer to Diagnostic Trouble Code (DTC) List - Vehicle .
- If no DTCs are set
Ignition ON, perform the Instrument Cluster Gauge Sweep test with the scan tool, verify that all gauges sweep from their low to high position.
- If any gauge does not sweep
  Replace the P16 Instrument Cluster.
- If all gauges sweep
Drive the vehicle, verify the gauge values matches the values on the scan tool.
- If the values do not match
  Replace the P16 Instrument Cluster.
- If the values match the scan tool
All OK.