Windshield Garnish Molding Replacement (Encore)

WARNING: This page is about a different car, the 2015 Chevrolet Trax and 2015 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Windshield Garnish Molding Assembly (Encore)

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
1	Windshield Garnish Molding Assembly Procedure Tabs must be installed prior to retainers. Tabs to be fully seated in the instrument panel (I/P) trim panel retainer and valance panel. Disconnect the electrical connector. The tether clip at the upper portion of the garnish molding MUST be replaced every time the windshield side garnish molding is removed.

Callout

Component Name

Windshield Garnish Molding Assembly

Procedure

Tabs must be installed prior to retainers.
Tabs to be fully seated in the instrument panel (I/P) trim panel retainer and valance panel.
Disconnect the electrical connector.
The tether clip at the upper portion of the garnish molding MUST be replaced every time the windshield side garnish molding is removed.