Rear Seat Back Bolster Replacement (AYF)

WARNING: This page is about a different car, the 2015 Chevrolet Trax and 2015 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Rear Seat Back Bolster (AYF)

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
1	Rear Seat Back Cushion Bolster WARNING: Refer to SIR Warning . Procedure Disable the SIR system. Refer to SIR Disabling and Enabling Fold rear seat back cushion down. Pull the upper pad area of the seat back cushion bolster forward. NOTE: Pull the upper pad area of the seat back cushion bolster forward without pulling on the retainer. The force to remove the retainer is increased when the retainer has tension on it. Use a suitable flat-bladed tool to release the retainer from the bolster's retaining bar. Pull the seat back cushion bolster up to remove it from the rear seat. Disconnect the electrical connector.

Callout

Component Name

Rear Seat Back Cushion Bolster

WARNING:

Refer to SIR Warning .

Procedure

Disable the SIR system. Refer to SIR Disabling and Enabling
Fold rear seat back cushion down.
Pull the upper pad area of the seat back cushion bolster forward.

NOTE:

Pull the upper pad area of the seat back cushion bolster forward without pulling on the retainer. The force to remove the retainer is increased when the retainer has tension on it.

Use a suitable flat-bladed tool to release the retainer from the bolster's retaining bar.
Pull the seat back cushion bolster up to remove it from the rear seat.
Disconnect the electrical connector.