Driver or Passenger Seat Removal and Installation

WARNING: This page is about a different car, the 2015 Chevrolet Trax and 2015 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Driver Or Passenger Seat

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
WARNING: Refer to SIR Warning . Preliminary Procedures Disable the SIR system. Refer to SIR Disabling and Enabling . Disable the front seat belt tensioner fastener by removing the cap, and cover, if equipped. Refer to Front Seat Belt Retractor Replacement (With A69) .
1	Front Seat Riser Finish Cover Procedure Remove the front seat riser cover. Refer to Front Seat Riser Finish Cover Replacement .
2	Front Seat Mounting Bolt (Qty: 2) CAUTION: Refer to Fastener Caution . Procedure Adjust the seat to the full forward position to gain access to the rear bolts. Tighten 40 N.m (30 lb ft)
3	Driver or Passenger Seat Assembly Procedure Disconnect the electrical connector. With the aid of an assistant remove the front seat, by tilting the seat forward and then lifting and pulling the seat rearwards to disengage the front hooks. Transfer components as necessary.