LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 18 (Wiring Systems And Power Management - Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> Tyco/AMP Connectors (Seat) >> Terminal Removal Procedure

Terminal Removal Procedure

WARNING: This page is about a different car, the 2015 Chevrolet Trax and 2015 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating Locking Slide Lever
    GM2146421Courtesy of GENERAL MOTORS COMPANY
  1. Grasp the locking slide lever and pull outward from the end of the connector.
    2. Fig 2: Pulling Slide Lever Out Of Mating Connector
    GM2146422Courtesy of GENERAL MOTORS COMPANY
  2. As the slide lever is pulled out the mating connector is lifted from the seated position.
    3. Fig 3: Pushing TPA Tabs Into Connector Body
    GM2146424Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Terminal position assurance (TPA) is keyed and can only be inserted in one direction.

  3. Using terminal release tool J-38125-11A or equivalent, push the TPA tabs into the connector body.
    4. Fig 4: Pulling TPA From Connector Body
    GM2146425Courtesy of GENERAL MOTORS COMPANY
  4. Pull the TPA from the connector body.
    5. Fig 5: Releasing Connector Wire Dress Cover Locking Tab
    GM2146426Courtesy of GENERAL MOTORS COMPANY
  5. Using terminal release tool J-38125-11A or equivalent, release the connector wire dress cover locking tab.
    6. Fig 6: Lifting Connector Wire Dress Cover From Connector Body
    GM2146427Courtesy of GENERAL MOTORS COMPANY
  6. With the lock tab released, lift the connector wire dress cover from the connector body.
    7. Fig 7: Using Terminal Release Tool
    GM2146428Courtesy of GENERAL MOTORS COMPANY
  7. Using terminal release tool J-38125-212, press the prongs into the holes each side of the terminal to be removed to release the lock tabs and pull the terminal out of the connector body.
    8. Fig 8: Using Terminal Release Tool
    GM2146429Courtesy of GENERAL MOTORS COMPANY
  8. Using terminal release tool J-38125-560, press the prongs into the holes on each side of the terminal to be removed to release the lock tabs and pull the terminal out of the connector body.
    9. Fig 9: Using Terminal Release Tool
    GM2146430Courtesy of GENERAL MOTORS COMPANY
  9. Using terminal release tool J-38125-556, press the prongs into the holes on each side of the terminal to be removed to release the lock tabs and pull the terminal out of the connector body.
  10. Repair the terminal by following the Repairing Connector Terminals (Terminated Lead Repair) Repairing Connector Terminals (Terminal Repair)  procedure.
  11. Insert the repaired terminal back into the cavity. Repeat the diagnostic procedure to verify the repair and reconnect the connector bodies.
scientia non olet · About LEMON Manuals