Removal Procedure

WARNING: This page is about a different car, the 2015 Chevrolet Trax and 2015 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Sliding Red CPA Away From Connector Lever

Courtesy of GENERAL MOTORS COMPANY

Using your thumbs press down and slide the red CPA away from the connector lever.

Fig 2: Pressing Down On Locking Tab - Tyco/AMP Connectors (SIR)

Courtesy of GENERAL MOTORS COMPANY

Using your thumb press down on the locking tab and move the lever to the released position.

Fig 3: Releasing Wire Dress Cover Locking Tabs

Courtesy of GENERAL MOTORS COMPANY

Using terminal tool J-38125-11A or equivalent, release the wire dress cover locking tabs.

Fig 4: Pivoting Connector Wire Dress Cover

Courtesy of GENERAL MOTORS COMPANY

Pivot connector wire dress cover while removing from the connector body.

Fig 5: Removing TPA

Courtesy of GENERAL MOTORS COMPANY

Using terminal tool J-38125-11A or equivalent, remove the TPA by lifting straight off the connector body.

Fig 6: View of Terminal Release Tool & Rear of Connector Body

Courtesy of GENERAL MOTORS COMPANY

Using terminal release tool J-38125-215A, place the tip of the tool on the outside edge next to the terminal and depress the lock tab and remove the rear of the connector body.