LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 18 (Wiring Systems And Power Management - Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> Splicing Copper Wire Using Splice Sleeves >> High Temperature Wiring Repairs

High Temperature Wiring Repairs

WARNING: This page is about a different car, the 2015 Chevrolet Trax and 2015 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.

Use the following procedures to perform high temperature wiring repairs:

  1. Center the high temperature SCT1 shrink tube over the DuraSeal splice sleeve.
  2. Using the heat torch, apply heat to the high temperature heat shrink tubing.
  3. Gradually move the heat from the center to the open end of the tubing:
    • The tubing will shrink completely as the heat is moved along the insulation.
    • A small amount of sealant will come out of the end of the tubing when sufficient shrinkage is achieved.
  4. Replace any reflective tape and clips that may have been removed during the repair.
scientia non olet · About LEMON Manuals