LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 18 (Wiring Systems And Power Management - Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> Power Mode Mismatch >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2015 Chevrolet Trax and 2015 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

The vehicle may not be equipped with all components as listed below. Use schematics to determine which ignition relay supplies the ignition feed for the appropriate devices. Use the connector end view to identify the ignition circuit terminal for each of those devices.

  1. Ignition ON.
  2. Verify that the appropriate devices controlled by the KR73 Ignition Main Relay (underhood) turn ON and OFF when commanding the Run/Crank Relay On and Off with a scan tool.
    • If the devices do not turn ON and OFF 

      Refer to Circuit/System Testing - Diagnostic A.

    • If the devices turn ON and OFF 
  3. Verify that the appropriate devices controlled by the KR73 Ignition Main Relay (rear body) turn ON and OFF when commanding the Run/Crank Relay On and Off with a scan tool.
    • If the devices do not turn ON and OFF 

      Refer to Circuit/System Testing - Diagnostic B.

    • If the devices turn ON and OFF 
  4. Verify that the appropriate devices controlled by the KR32E Blower Motor Relay turn ON and OFF when commanding the Auxiliary Ignition Run Relay On and Off with a scan tool.
    • If the devices do not turn ON and OFF 

      Refer to Circuit/System Testing - Diagnostic C.

    • If the devices turn ON and OFF 
  5. Verify that the appropriate devices controlled by the KR74 Ignition Run Relay turn ON and OFF when commanding the Auxiliary Ignition Run Relay On and Off with a scan tool.
    • If the devices do not turn ON and OFF 

      Refer to Circuit/System Testing - Diagnostic D.

    • If the devices turn ON and OFF 
  6. Verify that the appropriate devices controlled by the KR76 Retained Accessory Power Relay turn ON and OFF when commanding the Accessory/Retained Accessory Power Relay On and Off with a scan tool.
    • If the devices do not turn ON and OFF 

      Refer to Circuit/System Testing - Diagnostic E.

    • If the devices turn ON and OFF 
  7. Verify that the appropriate devices controlled by the KR75 Engine Controls Ignition Relay turn ON and OFF when cycling the ignition between ON and OFF.
    • If the devices do not turn ON and OFF 

      Refer to Circuit/System Testing - Diagnostic F.

    • If the devices turn ON and OFF 
  8. Verify that the appropriate devices controlled by the KR104A Battery Saver Relay 1 turn ON and OFF after enabling battery saver mode (transport mode).
    • If the devices do not turn ON and OFF 

      Refer to Circuit/System Testing - Diagnostic G.

    • If the devices turn ON and OFF 
  9. All OK.
scientia non olet · About LEMON Manuals