LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 18 (Wiring Systems And Power Management - Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> Delphi Connectors (Push To Seat) >> Terminal Insertion Procedure

Terminal Insertion Procedure

WARNING: This page is about a different car, the 2015 Chevrolet Trax and 2015 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
  1. In order to reuse a terminal or lead assembly, refer to Wiring Repairs .
  2. Ensure that the cable seal is kept on the terminal side of the splice.
  3. Insert the lead from the back until it catches.
  4. Install the TPA, CPA, and/or the secondary locks.
scientia non olet · About LEMON Manuals