LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 18 (Wiring Systems And Power Management - Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> DTC P2537: Ignition Accessory Switch >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2015 Chevrolet Trax and 2015 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the harness connector at the control module setting the DTC.
  2. Ignition ON.
  3. Verify a test lamp illuminates between the accessory wake up serial data circuit and ground.
    • If the test lamp does not illuminate. 
    1. Ignition OFF remove the test lamp, disconnect the X4 connector at the K9 Body Control Module.
    2. Test for less than 2 Ω on the ignition circuit end to end.
      • If 2 Ω or greater, repair the open/high resistance in the circuit.
      • If less than 2 Ω, replace the K9 Body Control Module.
    • If the test lamp illuminates 
  4. Replace the control module setting the DTC.
scientia non olet · About LEMON Manuals