LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 108 (Dangers, Warnings, And Cautions) >> Introduction >> Sensing and Diagnostic Module Handling Warning

Sensing and Diagnostic Module Handling Warning

WARNING: This page is about a different car, the 2016 Chevrolet Trax and 2016 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:

Be careful when you handle a sensing and diagnostic module (SDM). Do not strike or jolt the SDM. Before applying power to the SDM:

  • Remove any dirt, grease, etc. from the mounting surface
  • Position the SDM horizontally on the mounting surface
  • Point the arrow on the SDM toward the front of the vehicle
  • Tighten all of the SDM fasteners and SDM bracket fasteners to the specified torque value

Failure to follow the correct procedure could cause air bag deployment, personal injury, or unnecessary SIR system repairs.

scientia non olet · About LEMON Manuals