LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 103 (Tire Pressure Monitoring System) >> Diagnostic Information and Procedures >> DTC C0750, C0755, C0760, or C0765: Tire Pressure Sensor >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2015 Chevrolet Trax and 2015 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
  1. Verify there are no communication DTCs set along with DTC C0750, C0755, C0760, and C0765.
    • If a communication DTC is not set 
  2. Verify if all 4 tire monitor pressure sensor DTCs are not set.
    • If 2 or more tire monitor pressure sensor DTCs are set, test the keyless entry antenna for proper operation, or if antenna is properly seated. Refer to Keyless Entry System Malfunction
  3. Perform the Tire Pressure Indicator Sensor Learn .
  4. Verify the scan tool Tire Pressure Sensor Mode parameters change to Drive while driving the vehicle above 40 km/h (25 mph) for greater than 2 min.
    • If a Tire Pressure Sensor Mode parameter does not change to Drive 
    1. Replace the appropriate B2 Tire Pressure Sensor.
    2. Perform the Tire Pressure Indicator Sensor Learn .
    • If the Tire Pressure Sensor Mode parameter changes to Drive 
  5. All OK.
scientia non olet · About LEMON Manuals