LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 100 (Power Seat System) >> Diagnostic Information and Procedures >> Power Seat Malfunction (With Memory A45) >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2015 Chevrolet Trax and 2015 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition ON.
  2. Verify the scan tool seat switch parameters listed below change between Inactive and Forward/Rearward or Up/Down when pressing the appropriate switch.
    • Driver Seat Horizontal Switch
    • Driver Seat Cushion Front Vertical Switch
    • Driver Seat Cushion Rear Vertical Switch
    • If the parameter does not change 

      Refer to Circuit/System Testing - Driver Seat Adjuster Switch Circuit Test.

    • If the parameter changes 
  3. Verify the seat directional motors listed below operate while operating the appropriate driver seat switches in both directions.
    • M50D Seat Front Vertical Motor - Driver
    • M51D Seat Horizontal Motor - Driver
    • M55D Seat Rear Vertical Motor - Driver
    • If any seat motor does not operate 

      Refer to Circuit/System Testing - Seat Motor Control Circuit Test.

    • If all seat motors operate 
  4. All OK.
scientia non olet · About LEMON Manuals