LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 100 (Power Seat System) >> Diagnostic Information and Procedures >> DTC B3920: Driver Seat Motors Group 1 >> Conditions for Setting the DTC

Conditions for Setting the DTC

WARNING: This page is about a different car, the 2015 Chevrolet Trax and 2015 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.

B3920 00 

Current out of the module does not match the current returning to the module from 1.5-5 A.

B3920 01 

The voltage on any power rail 1 motor control circuit exceeds 2.78 V for 100 ms.

B3920 02 

The voltage on any power rail 1 motor control circuit is below 1.47 V for 100 ms.

B3920 42 

This DTC will set if the module calibration is not programmed.

B3920 0B 

The differential current measured through the high and low side of the power rail is within tolerance of each other, but the absolute current or an over-current has exceeded the maximum value.

scientia non olet · About LEMON Manuals