LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 100 (Power Seat System) >> Diagnostic Information and Procedures >> DTC B1735, B1740, B1745, B1750, B1755, B1760, B1815, or B1820: Driver Seat Switch >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2015 Chevrolet Trax and 2015 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition ON.
  2. Verify the scan tool seat switch parameters listed below change between Inactive and Forward/Rearward or UP/Down when pressing the appropriate seat directional switch.
    • Driver Seat Cushion Front Vertical Switch
    • Driver Seat Cushion Rear Vertical Switch
    • Driver Seat Horizontal Switch
    • If the parameter does not change 

      Refer to Circuit/System Testing.

    • If the parameter changes 
  3. All OK.
scientia non olet · About LEMON Manuals