LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> Engine Performance >> Testing & Diagnosis >> Engine Controls And Fuel - 1.4L (LUJ, LUV) - DTC P0300 To DTC P2635 And Diagnostic Information And Procedures >> Diagnostic Information and Procedures >> Service Bay Test >> Test Procedure

Test Procedure

NOTE:
  • If the Service Bay Test aborts or fails, a DTC will NOT be set.
  • You must not rush the scan tool selections or erroneous results or error messages could occur.
  1. Select the Service Bay Test with the scan tool.
  2. Follow the instructions on the scan tool. The EVAP Service Bay Test should complete and should not abort or fail.
    WARNING: Refer to Road Test Warning .
    • If the test aborts 

      Correct the condition for running the test, then retest.

      or

    • If the test fails 

      Repair the vehicle for the condition indicated by the failure message, then retest.

    • If the test passes 
      NOTE: There are several test parameters displayed and can vary by engine RPO.
  3. Verify that the EVAP Monitor Complete parameter, is set to YES.
scientia non olet · About LEMON Manuals