Conditions for Running the DTC

DTCs P0016, P0017, P0030, P0036, P0053, P0054, P0068, P0101, P0102, P0103, P0106, P0107, P0108, P0116, P0117, P0118, P0122, P0123, P0128, P0131-P0135, P0137, P0138, P013A, P013B, P013E, P013F, P0140, P0141, P015A, P015B, P0171, P0172, P0201-P0204, P0222, P0223, P0261, P0262, P0264, P0265, P0267, P0268, P0270, P0271, P0300, P0301-P0304, P0340, P0341, P0365, P0366, P0411, P0442, P0455, P0458, P0496, P1133, P1248, P1249, P124A, P124B, P16F3, P2101, P2135, P2147, P2148, P2150. P2151, P2153, P2154, P2156, P2157, P2270, P2271, P2440, P2444, P2A00 are not set.
The EVAP device control and intrusive diagnostics are not active.
The engine overspeed protection is not active.
The AIR pump is not ON, if equipped.
The engine is in closed loop status.
The system voltage is greater than 11 V.
The engine coolant temperature (ECT) is warmer than -20°C (-4°F).
The engine speed is between 1, 200-3, 200 RPM.
The mass air flow is between 10-100 g/s.
Engine run time is greater than 30 s.
Fuel level is greater than 10% and no fuel level sensor fault is present.
The DTC runs continuously when the above conditions have been met.