LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> Engine Performance >> Testing & Diagnosis >> Engine Controls And Fuel - 1.4L (LUJ, LUV) - DTC P0300 To DTC P2635 And Diagnostic Information And Procedures >> Diagnostic Information and Procedures >> DTC P0455: Evaporative Emission (EVAP) System >> Circuit/System Testing

Circuit/System Testing

IMPORTANT:
  • Larger volume fuel tanks and/or those with lower fuel levels may require several minutes for the floating indicator to stabilize or produce smoke from a leak.
  • Refer to the GE 41413-A  operation manual for detailed instructions in Evaporative Emission Control System Diagnosis .
  1. Disconnect the purge tube at the quick connector on the EVAP canister side of the purge solenoid valve and install the CH 48096  .
  2. Connect the GE 41413-A  to the vehicle EVAP service port adapter.
  3. Command the EVAP Purge/Seal function to System Seal with a scan tool to seal the EVAP system.
  4. Verify that there is no leak in the EVAP system using the flow meter on the GE 41413-A  , calibrated to 0.51 mm (0.020 in)..
    • If a leak is detected 
    1. Apply smoke to the EVAP system at the service access port adapter with the GE 41413-A  .
    2. Locate the leak using the GE 41413-SPT 
    • When the leak is located, repair or replace the affected component as necessary.
    • If no leak detected 
      NOTE: The steps below test for a restriction in the purge path.
  5. Connect the GE 41413-A  nitrogen/smoke hose to the J 41413-311  .
  6. Disconnect the hose at the fuel cap end of the GE 41415-30  and connect to the J 41413-311  .
  7. Install the GE 41415-30  , filler neck end only, to the vehicle.
  8. Engine idling, command the Purge/Seal function to System Seal with a scan tool to seal the system.
  9. Command the EVAP Purge Solenoid Valve to 30% with a scan tool.
  10. Verify the vacuum/pressure gauge on the GE 41413-A  and the scan tool Fuel Tank Pressure Sensor parameter both show vacuum.
    • If the vacuum/pressure gauge shows vacuum, but the FTP parameter does not show vacuum 

      Replace the B150 Fuel Tank Pressure Sensor.

    • If neither the FTP parameter nor the vacuum/pressure gauge shows vacuum 

      Repair the restriction in the purge path.

  11. Verify that the Fuel Tank Pressure Sensor parameter increases to greater than 3.2 V and the pressure values are similar between the scan tool Fuel Tank Pressure Sensor and the vacuum/pressure gauge on the GE 41413-A  .
    • If not within the specified range 

      Replace the B150 Fuel Tank Pressure Sensor.

    • If within the specified range 
  12. All OK
scientia non olet · About LEMON Manuals