Circuit/System Testing
NOTE:
Perform the Circuit/System Verification before proceeding with the Circuit/System Testing.
- Test for a blockage or restrictions in the EVAP system components listed below and repair as necessary.
- Evaporative emission vent system hoses
- Evaporative emission canister
- Q13 Evaporative Emission Vent Solenoid Valve
- Evaporative emission vent filter
- Reconnect all previously disconnected EVAP hardware.NOTE: Refer to the GE 41413-A operation manual for detailed instructions in Evaporative Emission Control System Diagnosis .
- Remove the fuel fill cap and connect the CH 41415-30 to the fuel tank filler neck. Connect the GE 41413-A to the CH 41415-30 .
- Command the EVAP Purge/Seal function to System Seal with a scan tool to seal the EVAP system.
- Turn the nitrogen/smoke valve on the GE 41413-A to nitrogen.
- Use the remote switch to activate the GE 41413-A
and pressurize the fuel tank to 5.0 in H20.NOTE: DO NOT exceed the specified value in this step. Exceeding the specified value may produce incorrect test results.
- Verify the scan tool Fuel Tank Pressure Sensor parameter is 0 in H20 when commanding the EVAP Vent Solenoid Valve to OFF.
- If not 0 in H20
Test for a blockage or a restriction in the EVAP vent hose or inlet. If the inlet or hose test normal, replace the Q13 Evaporative Emission Vent Solenoid Valve.
- If 0 in H20
- If not 0 in H20
- Operate the vehicle within the conditions for running the DTC. You may also operate the vehicle within the conditions that you observed from the freeze frame/failure records data.
- If the DTC sets
Refer to step 1 above.
- If the DTC does not set
- If the DTC sets
- All OK.