LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> Engine Performance >> Testing & Diagnosis >> Engine Controls And Fuel - 1.4L (LUJ, LUV) - DTC P0300 To DTC P2635 And Diagnostic Information And Procedures >> Diagnostic Information and Procedures >> DTC P0442: Evaporative Emission (EVAP) System >> Circuit/System Testing

Circuit/System Testing

NOTE:
  • Refer to the GE 41413-A  operation manual for detailed instructions in Evaporative Emission Control System Diagnosis 
  • Larger volume fuel tanks and/or those with lower fuel levels may require several minutes for the floating indicator to stabilize or produce smoke from a leak.
  • Ensure that the underbody temperature of the vehicle and the tester are similar.
  1. Disconnect the purge tube at the quick connector on the EVAP canister side of the Q12 Evaporative Emission Canister Purge Solenoid Valve and install the CH 48096  .
  2. Connect the GE 41413-A  to the CH 48096  .
  3. Command the EVAP Purge/Seal function to System Seal with a scan tool to seal the EVAP system.
  4. Use the flow meter on the GE 41413-A  , calibrated to 0.51 mm (0.020 in) to determine if there is a leak.
    • If a leak is detected 
    1. Use the GE 41413-A  to apply smoke to the EVAP system at the purge tube until the leak is located using the GE 41413-SPT 
    • No leak in the EVAP system 
  5. All OK.
scientia non olet · About LEMON Manuals