LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> Engine Performance >> Testing & Diagnosis >> Engine Controls And Fuel - 1.4L (LUJ, LUV) - DTC P0300 To DTC P2635 And Diagnostic Information And Procedures >> Diagnostic Information and Procedures >> DTC P0420: Catalyst System >> Repair Verification

Repair Verification

  1. Install any components that have been removed or replaced during diagnosis.
  2. Perform any adjustments, programming or setup procedures that are required when a component is removed or replaced.
  3. Clear the DTCs with a scan tool.
  4. Turn OFF the ignition for 60 s.
  5. Operate the vehicle within the Conditions for Running the DTC.
  6. Verify the scan tool Catalyst Monitor Not At Idle Test Conditions Met parameter changes to Yes.
    • If Yes is not displayed 

      Refer to step  5.

    • If Yes is displayed 
  7. When the conditions are safe, stop and idle the vehicle in gear (If equipped with automatic transmission) or neutral (If equipped with manual transmission).
  8. Verify the Catalyst Monitor Test Result parameter displays Pass when performing the steps listed below:
    1. Apply the service brake.
    2. Monitor the scan tool Catalyst Monitor Test State parameter. When the parameter indicates Active, the Catalyst Monitor Test is running.
    3. Continue to monitor the parameter. When the parameter indicates Inactive, the Catalyst Monitor Test has completed.
      NOTE: When the test has completed, the Catalyst Monitor Test Counter parameter will increment by one and the Catalyst Monitor Test Result parameter will indicate Passed, Failed or No Result.
    • If the Catalyst Monitor Test Result parameter indicates No Result 

      Repeat steps  58 until the Test Result parameter indicates Passed or Failed.

    • If the Catalyst Monitor Test Result parameter indicates Failed 

      Refer to Circuit/System Testing 

    • If the Catalyst Monitor Test Result parameter indicates Pass 
  9. All OK.