Component Testing
- Ignition Off, disconnect the harness connector at the Q6 Camshaft Position Actuator Solenoid Valve.
- Test for 7-12 Ω between the control terminal 2 and the low reference circuit terminal 1.
- If not between 7-12 Ω
Replace the Q6 Camshaft Position Actuator Solenoid Valve.
- If between 7-12 Ω
- If not between 7-12 Ω
- Test for infinite resistance between each terminal and the Q6 Camshaft Position Actuator Solenoid Valve housing.
- If not infinite resistance
Replace the Q6 Camshaft Position Actuator Solenoid Valve.
- If infinite resistance
- If not infinite resistance
- All OK