LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> Engine Mechanical >> Engine Mechanical - 1.4L (LUV) >> Repair Instructions - On Vehicle >> Powertrain Mount Balancing - Lower

Powertrain Mount Balancing - Lower

  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
    NOTE: Follow the balance procedure steps listed below when front or rear mounts through bolts are loosened or removed during a repair procedure.
  2. Loosen the front transaxle mount through bolt (1).
    Fig 1: Front Transaxle Mount Through Bolt
    GM2405098Courtesy of GENERAL MOTORS COMPANY
  3. Loosen the rear transaxle mount through bolt (1).
    Fig 2: Rear Transaxle Mount Through Bolt
    GM2405059Courtesy of GENERAL MOTORS COMPANY
  4. Shake the powertrain from front to rear and allow the powertrain to settle.
  5. Tighten the rear transaxle mount through bolt (1). See the appropriate transmission mount replacement procedure for the fastener tightening specifications.
    NOTE: It is essential that the through bolts are as close to centered as possible in the oversized mount insert holes before tightening to specification.
  6. Tighten the front transaxle mount through bolt (1). See the appropriate transmission mount replacement procedure for the fastener tightening specifications.
    Fig 3: Front Transaxle Mount Through Bolt
    GM2405098Courtesy of GENERAL MOTORS COMPANY
  7. Lower the vehicle.
scientia non olet · About LEMON Manuals