Installation Procedure

Clean the 6 screw bores. Rework if necessary.
Install the engine flywheel (1).

Fig 1: Engine Flywheel And Bolts
Courtesy of GENERAL MOTORS COMPANY
Install 6 NEW engine flywheel bolts (2).
Install EN-652 flywheel holder (1) in order to fix the engine flywheel (2).

Fig 2: Engine Flywheel And Holder
Courtesy of GENERAL MOTORS COMPANY
Tighten the 6 engine flywheel bolts in a cross sequence a first pass to 60 N.m (44 lb ft).
CAUTION: Refer to Fastener Caution .

CAUTION: Refer to Torque-to-Yield Fastener Caution .
Tighten the 6 engine flywheel bolts in a cross sequence a second pass to an additional 45°, using EN-470-B wrench.
Tighten the 6 engine flywheel bolts in a cross sequence a final pass to an additional 15°, using EN-470-B wrench.
Install clutch pressure and driven plate. Refer to Clutch Pressure and Driven Plate Replacement (1.4L LUV) .
Install transmission. Refer to Transmission Replacement .