LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> Engine Mechanical >> Engine Mechanical - 1.4L (LUV) >> Repair Instructions - On Vehicle >> Drive Belt Replacement >> Removal Procedure

Removal Procedure

  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the right front wheelhouse liner. Refer to Front Wheelhouse Liner Replacement .
  3. Rotate the drive belt tensioner pulley bolt (1) in the direction shown until the bore (2) aligns with the bore in the engine front cover, using a TORX wrench and hold in position.
    Fig 1: Drive Belt Tensioner Pulley And Bolt
    GM2538044Courtesy of GENERAL MOTORS COMPANY
  4. Install a suitable punch (1) through the drive belt tensioner bore (2) to the engine front cover bore to fix the tensioner in position.
    Fig 2: Punch Inserted In Drive Belt Tensioner Bore
    GM2538043Courtesy of GENERAL MOTORS COMPANY
  5. Lower the vehicle.
  6. Remove the right engine mount. Refer to Engine Mount Replacement - Right Side .
  7. Remove the drive belt (1).
    Fig 3: Drive Belt
    GM2538046Courtesy of GENERAL MOTORS COMPANY
scientia non olet · About LEMON Manuals