LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> Engine Mechanical >> Engine Mechanical - 1.4L (LUV) >> Repair Instructions - On Vehicle >> Crankshaft Rear Oil Seal Replacement (Automatic Transmission) >> Installation Procedure

Installation Procedure

  1. Slide the crankshaft rear oil seal (2) across the EN-235-6  installer (1).
    Fig 1: Crankshaft Rear Oil Seal
    GM2757896Courtesy of GENERAL MOTORS COMPANY
  2. Install the crankshaft rear oil seal (1) with EN-235-6  installer (2) to the crankshaft.
    Fig 2: Crankshaft Rear Oil Seal And Installer
    GM2190821Courtesy of GENERAL MOTORS COMPANY
  3. Use EN-658-1  installer (2) to strike the crankshaft rear oil seal (1)
    Fig 3: Oil Seal Installer
    GM2750534Courtesy of GENERAL MOTORS COMPANY
    NOTE: Ensure that the crankshaft rear oil seal fits proper.
  4. Remove the collecting basin.
  5. Install the automatic transmission flex plate. Refer to Automatic Transmission Flex Plate Replacement .
scientia non olet · About LEMON Manuals