LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> Engine Mechanical >> Engine Mechanical - 1.4L (LUV) >> Repair Instructions - Off Vehicle >> Piston, Connecting Rod and Bearing Removal

Piston, Connecting Rod and Bearing Removal

  1. Remove the 4 connecting rod bearing cap bolts (1) of cylinder 2 and 3.
    Fig 1: Connecting Rod Bearing Caps And Bolts
    GM2190741Courtesy of GENERAL MOTORS COMPANY
    NOTE: Mark the installation position of the connecting rod bearing caps. The connecting rod bearings and bearing caps must not be interchanged with other connecting rods.
  2. Remove the 2 connecting rod bearing caps (2) and the 2 connecting rod bearings of cylinder 2 and 3.
  3. Rotate the crankshaft 180 degrees.
    4. Fig 2: Connecting Rod Bearing Caps And Bolts
    GM2190742Courtesy of GENERAL MOTORS COMPANY
  4. Remove the 4 connecting rod bearing cap bolts (1) of cylinder 1 and 4.
  5. Remove the 2 connecting rod bearing caps (2) and the 2 connecting rod bearings of cylinder 1 and 4.
  6. Remove the 4 pistons (1) and connecting rods (2) and the 4 upper connecting rod bearings (3) from the cylinder block.
    Fig 3: Pistons, Connecting Rods And Bearings
    GM2190743Courtesy of GENERAL MOTORS COMPANY
scientia non olet · About LEMON Manuals