Drive Belt Installation

Special Tools

• EN-955  Locking Pins
• EN-48488  Holding Wrench

For equivalent regional tools, refer to Special Tools .

1. Install the drive belt.
   NOTE: Ensure that the drive belt tensioner is held with EN-955-2  locking pin.
2. Move the drive belt tensioner clockwise until EN-955-20  locking pin (2) can be removed. Use EN-48488  wrench (1).
   Fig 1: Locking Pin And Wrench

   Courtesy of GENERAL MOTORS COMPANY
3. Remove EN-955-20  locking pin (2) from the drive belt tensioner while holding with EN-48488  wrench (1).
4. Release tension from drive belt tensioner and remove EN-48488  wrench (1).