Fastener Specifications (1.8L LUW and LWE)
| Application | Specification | |
|---|---|---|
| Metric | English | |
| Catalytic Converter to Cylinder Head Nut | 20 N.m | 15 lb ft |
| Catalytic Converter to Exhaust Front Pipe Nut | 22 N.m | 16 lb ft |
| Engine Lift Bracket Bolt | 25 N.m | 19 lb ft |
| Engine Lift Bracket Stud and Nut | 25 N.m | 19 lb ft |
| Exhaust Front Hanger Bracket Bolt M8 | 22 N.m | 16 lb ft |
| Exhaust Front Hanger Bracket Bolt M10 (1) | ||
| First Pass | 60 N.m | 44 lb ft |
| Final Pass | 30-45 Degrees | |
| Exhaust Front Hanger Insulator Nut | 17 N.m | 13 lb ft |
| Exhaust Front Pipe to Exhaust Muffler Nut | 17 N.m | 13 lb ft |
| Exhaust Front Pipe-to-Underbody Shield Nut | 2.5 N.m | 22 lb in |
| Exhaust Front/Rear Muffler Shield Nut | 2.5 N.m | 22 lb in |
| Exhaust Manifold Brace Bolt (Catalytic Converter To Brace) | 20 N.m | 15 lb ft |
| Exhaust Manifold Brace Bolt (Brace To Engine Block) (1) | ||
| First Pass | 20 N.m | 15 lb ft |
| Final Pass | 30 - 45 Degrees | |
| Exhaust Manifold Heat Shield Bolt (bottom) | 8 N.m | 71 lb in |
| Exhaust Manifold Heat Shield Bolt (top) | 15 N.m | 11 lb ft |
| Exhaust Manifold Nut (1) | 20 N.m | 15 lb ft |
| Exhaust Pipe Clamp | 30 N.m | 22 lb ft |
| Heated Oxygen Sensor (2) | 42 N.m | 31 lb ft |
| Tank Heat Shield Bolt | 2.5 N.m | 22 lb in |
| Wiring Harness Bracket Bolt | 15 N.m | 11 lb ft |
| 1 = Use NEW Fastener. 2 = Use assembly paste (refer to Electronic Parts Catalog). |
||