LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> Engine Mechanical >> Engine Exhaust System >> Repair Instructions >> Exhaust Manifold Heat Shield Replacement (1.8L LUW and LWE) >> Removal Procedure

Removal Procedure

WARNING: Refer to Exhaust Service Warning .
WARNING: Refer to Protective Goggles and Glove Warning .
  1. Open the hood.
  2. Disconnect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection .
  3. Disconnect the heated oxygen sensor wiring harness plug.
  4. Remove the oil level indicator tube. Refer to Oil Level Indicator Tube Replacement .
  5. Remove the wiring harness bracket bolt (2) and the wiring harness bracket (1).
    Fig 1: Wiring Harness Bracket And Exhaust Manifold Heat Shield
    GM2027674Courtesy of GENERAL MOTORS COMPANY
  6. Remove the 2 exhaust manifold heat shield bolts (4).
  7. Remove the exhaust manifold heat shield (3).
scientia non olet · About LEMON Manuals