LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> Engine Mechanical >> Cooling System (Mechanical) >> Engine Cooling System >> Repair Instructions >> Water Pump Replacement (1.4L LUV) >> Removal Procedure

Removal Procedure

  1. Drain the cooling system.» Cooling System Draining and Filling (GE-47716 Fill)  and Cooling System Draining and Filling (Static Fill) 
  2. Engine Coolant Thermostat Housing Replacement (1.4L LUV) »Remove
  3. Water Pump Pulley Replacement (1.4L LUV) »Remove
  4. Heater Outlet Hose Replacement (1.4L LUV) »Remove
    NOTE: Remove the hose ONLY from the water pump.
  5. Remove and DISCARD the 2 front cover bolts (1, 8).
    Fig 1: Identifying Bolts
    GM3978321Courtesy of GENERAL MOTORS COMPANY
  6. Remove the remaining 8 bolts (2-7, 9, 10).
  7. The water pump and engine front cover bolts are located as followed:
    1. Engine front cover special bolt without cone end 60 mm (2.362 in) (1, 10).
    2. Engine front cover standard bolt with cone end 52 mm (2.047 in) (2, 6, 8).
    3. Water pump bolt 25 mm (0.984 in) (3-5, 7, 9).
  8. Water Pump (2) »Remove
    Fig 2: Identifying Gasket And Water Pump
    GM3978322Courtesy of GENERAL MOTORS COMPANY
  9. Remove and DISCARD the gasket.(1)
scientia non olet · About LEMON Manuals