Circuit/System Testing
- Ignition OFF, disconnect the harness connector at the G10 Cooling Fan Motor.
- Verify that a test lamp illuminates between the ground circuit terminal 4 and B+.
- If the test lamp does not illuminate
- Ignition OFF, remove the test lamp.
- Test for less than 2 Ω in the ground circuit end to end.
- If 2 Ω or greater, repair the open/high resistance in the circuit.
- If less than 2 Ω, repair the open/high resistance in the ground connection.
- If the test lamp illuminates
- Test or replace the G10 Cooling Fan Motor.