LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> Electrical >> Motors, Switches, Relays >> Wiring Systems And Power Management - Repair Instructions >> Repair Instructions >> Relay Replacement (Attached to Wire Harness) >> Removal Procedure

Removal Procedure

  1. Locate the relay. Refer to the Master Electrical Component List to locate the relay in the vehicle.
    Fig 1: Identifying Relay & Wire Harness Connector
    GM791846Courtesy of GENERAL MOTORS COMPANY
  2. Remove any fasteners which hold the relay in place.
  3. Remove any connector position assurance (CPA) devices or secondary locks.
  4. Separate the relay (1) from the wire harness connector (2).
    NOTE: Use care when removing a relay in a wiring harness when the relay is secured by fasteners or tape.
scientia non olet · About LEMON Manuals