LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> Electrical >> Motors, Switches, Relays >> Wiring Systems And Power Management - Diagnostic Information And Procedures >> Diagnostic Information and Procedures >> Vehicle Will Not Change Power Mode >> Component Testing >> S38 Ignition Mode Switch

S38 Ignition Mode Switch

  1. Ignition OFF, disconnect the harness connector at the S38 Ignition Mode Switch.
  2. With the S38 Ignition Mode Switch released, test for 4.5-5.5 kΩ between the terminals listed below:
    • Signal terminal 6 and ground terminal 4
    • Signal terminal 3 and low reference terminal 7
    • If not between 4.5-5.5 kΩ 

      Replace the S38 Ignition Mode Switch

    • If between 4.5-5.5 kΩ 
  3. With the S38 Ignition Mode Switch pressed, test for 1-1.5 kΩ between the terminals listed below:
    • Signal terminal 6 and ground terminal 4
    • Signal terminal 3 and low reference terminal 7
    • If not between 1-1.5 kΩ 

      Replace the S38 Ignition Mode Switch.

    • If between 1-1.5 kΩ 
  4. All OK.
scientia non olet · About LEMON Manuals