Removal Procedure

Using your thumbs press down and slide the red CPA away from the connector lever.

Fig 1: Sliding Red CPA Away From Connector Lever
Courtesy of GENERAL MOTORS COMPANY
Using your thumb press down on the locking tab and move the lever to the released position.

Fig 2: Pressing Down On Locking Tab - Tyco/AMP Connectors (SIR)
Courtesy of GENERAL MOTORS COMPANY
Using terminal tool J-38125-11A or equivalent, release the wire dress cover locking tabs.

Fig 3: Releasing Wire Dress Cover Locking Tabs
Courtesy of GENERAL MOTORS COMPANY
Pivot connector wire dress cover while removing from the connector body.

Fig 4: Pivoting Connector Wire Dress Cover
Courtesy of GENERAL MOTORS COMPANY
Using terminal tool J-38125-11A or equivalent, remove the TPA by lifting straight off the connector body.

Fig 5: Removing TPA
Courtesy of GENERAL MOTORS COMPANY
Using terminal release tool J-38125-215A, place the tip of the tool on the outside edge next to the terminal and depress the lock tab and remove the rear of the connector body.

Fig 6: View of Terminal Release Tool & Rear of Connector Body
Courtesy of GENERAL MOTORS COMPANY