LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> Electrical >> Motors, Switches, Relays >> Wiring Systems And Power Management - Diagnostic Information And Procedures >> Diagnostic Information and Procedures >> FCI Connectors (SIR) >> Removal Procedure

Removal Procedure

NOTE: The orange or yellow connector position assurance (CPA) must be released first to disconnect or to connect the connector.
  1. Lift the orange or yellow CPA vertically (avoid lifting on an angle to the connector) approximately 4 mm to release the connector. Use a small flat-bladed tool to help release the CPA. The CPA may also be released manually without any tools.
    Fig 1: Lifting Orange CPA
    GM2374625Courtesy of GENERAL MOTORS COMPANY
  2. Grab the connector on both sides and lift vertically to disconnect the connector.
    Fig 2: Grabbing Connector On Both Sides
    GM3258545Courtesy of GENERAL MOTORS COMPANY
scientia non olet · About LEMON Manuals