Component Testing
- Ignition OFF, disconnect the harness connector at the S39 Ignition Switch.
- Using the Resistance Test below, verify the resistance between the terminals listed below match for each S39 Ignition Switch position.
- If any reading is other than specified
Replace the S39 Ignition Switch.
- If the readings match
- If any reading is other than specified
- All OK.
Resistance Test
| Ignition Switch Position | Terminals 1 and 2 | Terminals 2 and 3 | Terminals 2 and 4 | Terminals 2 and 6 | Terminals 4 and 6 |
|---|---|---|---|---|---|
| OFF Key Out | Infinite | Infinite | Infinite | Infinite | Infinite |
| OFF Key In | Infinite | Infinite | <5.0 Ω | Infinite | Infinite |
| ACCESSORY | Infinite | <5.0 Ω | Infinite | Infinite | Infinite |
| ON/RUN | <5.0 Ω | <5.0 Ω | Infinite | Infinite | <5.0 Ω |
| CRANK | <5.0 Ω | Infinite | Infinite | Infinite | 1275-1325 Ω |