LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> Electrical >> Motors, Switches, Relays >> Wiring Systems And Power Management - Diagnostic Information And Procedures >> Diagnostic Information and Procedures >> DTC B097B: Power Mode Start Switch Circuit >> Component Testing

Component Testing

  1. Ignition OFF, disconnect the harness connector at the S38 Ignition Mode Switch.
  2. Test for 4.5-5.5 kΩ between the terminals listed below with the S38 Ignition Mode Switch released,
    • Signal terminal 6 and ground terminal 4
    • Signal terminal 3 and low reference terminal 7
    • If not between 4.5-5.5 kΩ 

      Replace the S38 Ignition Mode Switch.

    • If between 4.5-5.5 kΩ 
  3. Test for 1-1.5 kΩ between the terminals listed below with the S38 Ignition Mode Switch pressed.
    • Signal terminal 6 and ground terminal 4
    • Signal terminal 3 and low reference terminal 7
    • If not between 1-1.5 kΩ 

      Replace the S38 Ignition Mode Switch.

    • If between 1-1.5 kΩ 
  4. All OK.
scientia non olet · About LEMON Manuals