Circuit/System Verification
- Test drive the vehicle in a straight line at a speed greater than 40 km/h (25 MPH).
- Verify all scan tool Wheel Speed Sensor parameters are within 1.6 km/h (1 MPH) of each other.
- If any parameter is not within 1.6 km/h (1 MPH) of each other
Refer to Circuit/System Testing
- If each parameter is within 1.6 km/h (1 MPH) of each other
- If any parameter is not within 1.6 km/h (1 MPH) of each other
- All OK.