LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Hydraulic Brake System >> Diagnostic Information and Procedures >> DTC C0267: Low Brake Fluid >> Circuit/System Testing

Circuit/System Testing

  1. Ignition OFF, disconnect the harness connector at the B20 Brake Fluid Level Switch.
  2. Test for less than 10 Ω between the ground circuit terminal 2 and ground.
    • If 10 Ω or greater 
    1. Ignition OFF.
    2. Test for less than 2 Ω in the ground circuit end to end.
      • If 2 Ω or greater, repair the open/high resistance in the circuit.
      • If less than 2 Ω, repair the open/high resistance in the ground connection.
    • If less than 10 Ω 
  3. Ignition ON.
  4. Verify the scan tool Brake Fluid Level Sensor parameter is Low.
    • If the parameter is not Low 
    1. Ignition OFF, disconnect the harness connector at the K17 Electronic Brake Control Module.
    2. Test for infinite resistance between the signal circuit terminal 1 and ground.
      • If less than infinite resistance, repair the short to ground on the circuit.
      • If infinite resistance, replace the K17 Electronic Brake Control Module.
    • If the parameter is Low 
  5. Install a 3 A fused jumper wire between the signal circuit terminal 1 and ground.
  6. Verify the scan tool Brake Fluid Level Sensor parameter is Ok.
    • If the parameter is not Ok 
    1. Ignition OFF, disconnect the harness connector at the K17 Electronic Brake Control Module, ignition ON.
    2. Test for less than 1 V between the signal circuit and ground.
      • If 1 V or greater, repair the short to voltage on the circuit.
      • If less than 1 V.
    3. Test for less than 2 Ω in the signal circuit end to end.
      • If 2 Ω or greater, repair the open/high resistance in the circuit.
      • If less than 2 Ω, replace the K17 Electronic Brake Control Module.
    • If the parameter is Ok 
  7. Test or replace the B20 Brake Fluid Level Switch.