LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Drum Brake System >> Repair Instructions >> Rear Brake Cylinder Replacement >> Removal Procedure

Removal Procedure

WARNING: Refer to Brake Dust Warning .
WARNING: Refer to Brake Fluid Irritant Warning .
CAUTION: Refer to Brake Fluid Effects on Paint and Electrical Components Caution .
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  3. Remove the brake drum. Refer to Brake Drum Replacement .
  4. Remove the brake shoes. Refer to Brake Shoe Replacement .
  5. Clean any debris and contaminants from around the wheel cylinder.
  6. Disconnect the brake pipe fitting (1) from the wheel cylinder. Cap the exposed brake pipe end to prevent fluid loss.
    Fig 1: Brake Pipe Fitting And Wheel Cylinder Mounting Bolts
    GM2027657Courtesy of GENERAL MOTORS COMPANY
  7. Remove the 2 wheel cylinder mounting bolts (2).
  8. Remove the wheel cylinder (1) from the backing plate.
    Fig 2: Wheel Cylinder
    GM2027659Courtesy of GENERAL MOTORS COMPANY
scientia non olet · About LEMON Manuals