LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Disc Brake System >> Repair Instructions >> Rear Brake Shield Replacement >> Removal Procedure

Removal Procedure

  1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  3. Remove the brake rotor. Refer to Rear Brake Rotor Replacement .
  4. Remove the wheel speed sensor bolt (1).
    Fig 1: Wheel Speed Sensor And Wheel Speed Sensor Mounting Bolt
    GM2027694Courtesy of GENERAL MOTORS COMPANY
    CAUTION: Support the brake caliper with heavy mechanic wire or equivalent, whenever it is separated from its mount and the hydraulic flexible brake hose is still connected. Failure to support the caliper in this manner will cause the flexible brake hose to bear the weight of the caliper, which may cause damage to the brake hose and in turn may cause a brake fluid leak.
  5. Remove the wheel speed sensor (2).
  6. Remove the wheel bearing/hub mounting bolts (1).
    Fig 2: Wheel Bearing/Hub Mounting Bolts
    GM2027695Courtesy of GENERAL MOTORS COMPANY
  7. Remove the wheel bearing/hub assembly (2) and rear brake shield (1) from the rear axle assembly.
    Fig 3: Wheel Bearing/Hub, Rear Brake Shield And Steering Knuckle
    GM2027698Courtesy of GENERAL MOTORS COMPANY
scientia non olet · About LEMON Manuals